DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(102 votes) Published: Jun 26, 2007 8:42 p.m. In 3 Favorites Lists Viewed 389 times
In this egg I will show you how a basic guide on how to take fingerprints off of a flat surface.
Materials needed ~ Pencil lead
~ A Coin of some sort
~ A brush or feather
~ Clear Tape
~ And a sheet of paper
Step One
Sharpen a pencil and break the tip off, or get some mechanical pencil lead and break into small bits.
Step Two
Grab your coin and start to crush up your pencil lead until it becames a fine powder, and pour it onto the sheet of paper.
Step Three
Pour the crushed pencil lead onto the fingerprint, the pencil lead will stick to the oils of the fingerprint.
Step Four
Using the brush or feather, dust off the crushed pencil lead, and you will see a fngerprint.
Step Five
Grab your tape and press it down on top of the fingerprint for a moment lift the tape up and stick it to the peice of paper.
And you are done, if you followed my steps you should have a decent looking fingerprint on a piece of paper.
Jan 22, 2008 1:52 am - i lernt this in primarty school
but there we just used flour
and the same stuff that gymnist use on there hands before they do there stuff
Feb 11, 2008 9:34 am - 5* but the lead should be ground down EXTREMELY finely so it can accurately ’draw’ a fingerprint or the picture will be very ’pixelated’
Edit Page
Message Calamari
Add Comment
Add to Favorites
Email to Friend
