DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(127 votes) Published: Nov 08, 2007 5:32 p.m. In 3 Favorites Lists Viewed 915 times
this is very dangerous and i discovered it by accident
what you need: keyboard cleaner (little air tube that comes with it optional)
hotwater(optional not shown)
safety pin
snips (pliers that can cut)
how make ammunition take the safety pin and cut off the sharo oart from the rest
now load the bullet into the barel (air tube of the keyboard cleaner) below is loaded
now aim
squeze hard thats why its tilted and see near my hand that the safety bullet below
now to asses the damage a close up
that is embeded 2/4inch
this is my first trial with new my own pictures hope its not to bad
Nov 08, 2007 5:45 pm - lol 1/2 an inch bullshit ,this is common sense so 2* for effort show a vid and maybe ill 5* your profile, also why it everyones last posts showing in my blank box thing?
Nov 08, 2007 5:46 pm - hey that is quarter inch sheet rock from 5 feet away
Nov 08, 2007 5:47 pm - the last pic I checked the stats on the pic (focal lens length and such, and they ARE your pics, but, I still doubt the power majorly.
Nov 08, 2007 6:08 pm - its for super powering the can it cause the argon i think in the can to turn to gas then squeze the trigger and is 3 times more powerfull whic is how i did the 1/2 inch and i used a different bullet to get the 1/2 inch im not going to teach people here how to make it cause its to hard to make twice
Nov 08, 2007 8:07 pm - I gave 3 stars as to not alter the rating, but to give you some points to make a few more eggs. I call bullshit on half an inch, maybe 1/4 of an inch..
Put a small ball of tissue behind it for some wadding, will work a LOT better.
Nov 09, 2007 2:04 am - Dont give this guy shit, this is a good egg, and how can u say too much effort for little payoff??? its just a can of air, take the needle clip it, shove it in the tube what requires so much effort for that?? 5* to you dude good original egg :D
so half an inch? thats over 1cm. considering that the average safety pin’s sharp bit is less than 3cm long, id have to agree that doesnt hold with the pic atall.
Edit Page
Message PYRO1047
Add Comment
Add to Favorites
Email to Friend
