DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(19 votes) Published: Jun 18, 2001 12:00 a.m. Viewed 204 times
The most important thing in this is for you to obtain a a plastic spray gun (one of those gun shaped tools that you hook aerosaul cans onto and pull the trigger to spray). Take a drill bit and carefully drill a hole a half an inch away from the top back. then carve an inch gap in the top back. now get your hands on a nut about a half inch in width and weld a spike shaped piece of metal to it. Then weld and eyelet on the other side of the nut. slide the nut into the gap and compromise it with a quarterinch pin (this depends on how big your nut is). here comes the tricky part. take another eyelet and get it hot. then press it onto the tip at a 75 degree angle. Then buy a refillable butain wand. now get 3 short screws hot and stick them to the top of the wand flip it over and stick it to the top of the gun about an eighth inch away from the hammer. once it cool take some fishing line and thread it through though eylet on the hammer and tie it tight so when you pull back on the hammer the wand lights. now take some more fishing line and tie it into the eyeletthen thread it to the eyelet at the end now take a match and drench it in lighter fluid. tie the match to the fishing line and put it into the eyelt where it hangs. when you pull the hammer back it should light the wand and pull match up and light that once it is let go the match will drape in front of the aerosal can now pull the trigger and burn things.
Edit Page
Message HiroshuMaul
Add Comment
Add to Favorites
Email to Friend
