DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(20 votes) Published: Jul 07, 2005 12:55 a.m. In 1 Favorites Lists Viewed 355 times
you will need:
for launcher: 1 glove cannon\gun
or :
1 piece pvc pipe(white plastic hollow pipe used in plumbing) ,40cm long (10 inch i think) by
3-4 cm diameter (1- 1 1/2 inches i think)
1 stretchy dishwashing glove
wolf, gaffa or electrical tape.
for exploding projectile:
as many bullets as you desire to use OR
some blackpowder
smoke bomb mixture
1 piece of tube small enought to fit inside glove gun/ pvc pipe you will make the launcher from, i used a test tube
directions:
------------------------------------------------
1.launcher
1.1 cut the straightest finger from the glove and strecth over end of pvc pipe
1.2 wrap gaffer/electrical tape around the end of the pipe to attach the glove to the pipe. do this for several layers
you now have your launcher. this will alaso launch baall bearings, lead sinkers, etc. etc. HIGHLY DANGEROUS TO FIRE AT PEOPLE
------------------------------------------------
2 projectile
2.1 seal one end of your pipe firmly, unless using a test tube, clay works well for this.
2.2 pour in your black powder or pull the nose from a bullet with plyers and pour in the gun powder. if your using smoke mixture as well only put in enough back powder for a bang at the end.
2.3 put a fuse or sparkler the length of the tube
2.4 put smoke mixture into pipe
2.5 seal around remaining ennd, leaving space for fuse and enough air for combustion
2.6 cut fuse as short as possible for a midair explosion, plus a few seconds to load and launch it
----------------------------------------------------
to use light fuse and put in launcher with fuse towards where you’re aiming and launch.
my friend accidentally started a fire by aiming to low as it hit the ground before exploding
enjoy
Jul 09, 2005 1:25 am - you can make a smoke mixture from household ingredients by putting naill polish remover, the kind with acetone, in a bottle and a putting pieces of pingpong ball in, drag out the putty you get, put it into a mold and let it dry.
Feb 15, 2006 9:42 am - Molotov Cocktail You can make molotov cocktail projectiles as well!
What you need is a small glass bottle, and 1/4 fill it with petrol/alcohol/meths or any other highly flammable liquid. Then stuff a rag in the lid hole, and light it, and launch it.
Only 1/4 fill the bottle or else the rag might ignite the fuel INSIDE the bottle, and then it will explode.
If you use petrol, you could also mix it 50/50 ratio with motor oil, as then it will be thick and sticky!
you may want to investigate other means of attaching a flame to the bottle.
I have only launch a few molotovs from a glove gun.
I normally attach a molotov cocktail to the end of a crossbow bolt and launch it from my 225lb draw weight crossbow. It launches them 300yds!
Great fun really!
Have fun! (But be safe! It hurts if you get it wrong!)
Edit Page
Message oli-615
Add Comment
Add to Favorites
Email to Friend
