DO NOT TRY THIS AT HOME : Our text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(149 votes) Published: Aug 16, 2005 3:00 a.m. In 8 Favorites Lists Viewed 2386 times
Ok i have posted this b4 but it has been forgotten so i will tell you again!
ok first you will need:
12 inches of thin copper wire (30cm)
1 box of matches
2 9volt batteries 0r 6 volt bateries
explosive (homemade c4 or whatever can be moulded into a shape)
Ok now get 1 match and start to coil the wire around the red end of the match from the middle so the you have two ends of the wire, this must be tight so go aroung untill the wire has about 9 inches left.
make your explosive (look at my other eggs they will tell you a few good ones!)and mould it around the match so that when the wire heats up it lights the match and that ignites the explosive!
now get the loose ends of the copper wire and join one to the positive terminal of one battery (DONT JOIN THE OTHER ONE YET!!!)link the batteries with some left over wire positive to positive then slowly negative to negative now join the other end of loose wire to the negative. Now you have compleated the circuit!
the coiling of the wire makes it get hot and light the match!
thanx for reading if you need explosives look at my other eggs!
sorry it was so long but its good again...
here is what it does to a car with 500g of AP Putty...
Edit Page
Message xX_PsYcHo_Xx
Add Comment
Add to Favorites
Email to Friend
