DO NOT TRY THIS AT HOME : Our text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(109 votes) Published: Jul 05, 2006 4:53 a.m. In 3 Favorites Lists Viewed 712 times
This is a guide on how to make a pipe out of a puffer(see above).
As a child i had asthma, therefor i had to use a puffer to help my breathing only when i got sick. Earlier this evening i found an old puffer and thought of what i could do with it, the result is what i call, The sickmans pipe.
Items Needed:
In the image there are:
-a snap fitting(for a hose or something)
-a puffer(if you can’t get one use one of those tag body shots. They should work.)
-solder
-a drill bit
-MISSING- a hacksaw(this is needed)
STEP 1 Take your snap fitting and disassemble it completly
Now you want to throw out what is to the left of the following picture
STEP 2 Now you should have the fitting piece with a small mesh screen.Take the screen and force it into the smaller part of the fitting.
STEP 3 Now take the puffer. Get a pair of plier and pull the nossel for as long as you can to equilize a bit of the pressure. Once its stop spraying get the hacksaw and cut the red line in the picture.
The line is at my thumb joint.
STEP 4 Now take your hacksaw again and cut the red line in the following picture
STEP 5 Now take your snap fitting and place it into the wider hole. After this take a long piece of duct tape and wrap it around to secure the snap fitting to the puffer casing.
STEP 6 Now just place something over the small hole to stop you from cutting your lips.
I hope you enjoyed this egg. And FYI i wrote this completly myself no outside help. Check for yourselves and rate high!
Edit Page
Message Cirone
Add Comment
Add to Favorites
Email to Friend
