DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(67 votes) Published: Jul 19, 2006 8:57 p.m. In 1 Favorites Lists Viewed 336 times
How to make a plunger bong.....
PLUNGER BONG
The plunger bong AKA a waterless gravity bong is very simple to make and it’ll kick your fuckin ass. If your friends don’t smoke alot of pot and you want to get them really fucked up make them hit this one or two times. It’s a really easy project to do and is well worth the money.The longer the pipes are the better.....buy both pipes the same length.
You can use any size pipes but they should be atleast 4 feet long to make one that’ll kick your ass in a couple of hits.
SUPPLIES NEEDED
1) one cap for smaller pipe(threaded)
2) one cap for larger pipe (threaded)
3) one pvc pipe and a smaller one that fits inside it and is air tight ( make sure atleast one of the ends is threaded on each pipe)
4) a cheap metal bowl
5) a knife or a drill
6) sandpaper
get sand paper and sand down the smaller pvc pipe so that it slides in and out of the larger pvc pipe smoothly but is still air tight.
Drill or cut a whole in the smaller cap bigg enough for a metal bowl to fit into and put the bowl in the cap.
Screw on both caps.
Insert small pipe into large pipe.
Make sure everything is air tight.
Pack desired bowl size.
place against wall or have a friend hold it at one end.
Light that shit and slowly pull the smaller pipe out slowly so that the chamber will fill up with a thick smoke.
Once fully or almost fully extended and it is filled up with smoke screw off cap and run towards the wall, friend, or what ever is keeping it in place.