DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(38 votes) Published: Dec 17, 2002 12:00 a.m. In 1 Favorites Lists Viewed 1159 times
This is my first post tell me what you think and I havent seen this before on here.
Ok Ive made a couple of these there quick, and easy to make kind of strong depending on what kind of fuel you put in them. They can melt but last for quite a while.
List of Materials
--Bottle or anything with a screw on lid ECT
--Pen or a skinny marker works too
--Lighter
--Butane Lighter Sparker you can get an old
butane lighter take it apart and take the
sparker out
--Wire
--glue gun to glue everything together regular
glue if you want to wait
--Tape (optional)
--Sewing Needle or something like it
--Pliers to hold the needle after its hot
Ok Im going to try my best to describe this it isnt hard at all
1. Take the medicine bottle and the lighter and heat up the bottom of the bottle.
2. After it’s just a little warm and soft take the pen or whatever you use and stick it in the soft part
3. Take the needle and lighter heat the needle up stick it in the bottle’s side somewhere near the cap. Then do the same to other side reheat the needle if necessary
4. Stick one wire through one hole and another through the other hole. Glue them in place and glue the pen in place
5. You’re done.
6. Place a something in the hole small enough to fit in but not to small you want to get enough compression for a good shot. To big and it just stays in the pen.
7. Spray a fuel of your liking in the bottle put cap on, and press the sparkers button.
If it doesn’t spark take cap off and let a little air in put cap back on and try again
Feb 19, 2007 6:40 am - ive tried to make them in the past but they just dont work. i dont know if its the fuel air ratio or the spark not egniting it *3