DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(103 votes) Published: Oct 09, 2006 6:13 p.m. In 3 Favorites Lists Viewed 896 times
I was bored one day so I made a blowgun and some darts (not going to post that as theres already a load of eggs) but after a while I began needing an ammo holder.
Please note I have a thin blowgun and it may not work on thick ones.
I began my search for the perfect materials and found out that you can make a perfect ammo holder with:
-2X party poppers
-1X sponge
-1X roll of E-tape
First get your party poppers and cut the back open (where the charge is) like this and empty out the insides/remove lables. the hole needs to be roughly the same size as your blowgun.
Then take your sponge and rip off the scouring pad (if it has one) and cut it in half along the line shown.
Then you may need to cut a strip from one half to go on the other.
Tape the two party poppers together. so the ’buisiness ends’ are facing each other.
Wrap the sponge around the party poppers.
Tape it all up but not too tight.
Then slot it on and insert your ammo point first into sponge.
Oct 10, 2006 1:19 pm - it works well for its simplicity and with pin tipped ot simaler darts it should last a good while but for larger tips i havnt tested it but will be making a seperate quiver for on a belt for them
Oct 13, 2006 6:29 am - its quite ingenious but i do not like your blowgun darts you cannot get very efficiant range or accuracy out of them i mean they are allright but try my darts 5*