DO NOT TRY THIS AT HOME : Rotteneggs.com text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(164 votes) Published: Dec 28, 2006 11:39 a.m. In 3 Favorites Lists Viewed 1535 times
hey guys, have you ever had your picture taken and then when
the bright light flashes at you, you cant see for a while and it
annoys the hell out of you. well i have found the perfect way to
get this to happen to your friends.
Materials needed:
disposable camera
switch
push button
wires
soldering iron
well first off take your disposable camera and remove the
battery so you don’t get shocked. next open it up and remove
the camera board. you should be left with this..
now you must take your soldering iron and here comes the
hard part... there are two metal rods on the right side... you
must attach your push button to those rods with some wires.
these are the two rods you must solder... -push button now get your switch and you must attack the switch to
these metal ends with wires as well (as shown below)-switch
you should now be left with this...
break a hole in your camera where you would normally press
down like so...
next i would snap off the end of the camera you don’t need
like so (it saves room and we can just bring the push button
right up)
now after the wires are run through the camera, you may have
to solder your camera if it does not close right make sure
you can snap it in with these...
now hot glue the switch and push button in place
next place the battery back in and WALA you now have a flash machine.
i also soldered a hole out right next to the part where you look
through because even though you might turn the switch off
there is still a possibility of getting shocked so i place tinfoil by
the whole and when you turn it off just press the tinfoil down
and you should hear and see a spark (the tinfoil will not shock you)
... now there is no electricity in there so you can touch what you want.. this
does not break the camera or affect how it will work after
i do this all the time and it still works fine. (like so)
when you flip the switch on it should charge the flash and you
can leave the switch on because when you hit the flash button
each time a bright flash will come out. good for annoying friends
and what not.
Dec 28, 2006 3:24 pm - I gave myself a really bad shock doing this quite a while ago, you really do need to take out the battery.
they pack on hell of a punch.
Dec 28, 2006 5:10 pm - i made a flash machine because i was bored and its fun to temporarily blind people. also have you taken a look at your eggs who are you to flame me you n00b and as far as rap goes i don’t like rap i was at my friends house doing this (check out my groups, one of them being anti rap)
Mar 09, 2007 9:35 pm - trust me getting shocked by a flash capacitor hurts like a bitch.. don’t get shocked. look inside the camera find a capacitor and short out its leads with a screwdriver or w/e to wipe out the charge. that thing holds 300+ volts. thats 3x whats in ur wall outlets. hurts like fuckkkkkkk. 4* only bcus the way it looks when u made it is sloppy as hell. u need to make it a lot smaller/neater.
Edit Page
Message avp7x
Add Comment
Add to Favorites
Email to Friend
