This will set off a firecracker under a car
when the owner turns the key to start the engine....
Tools-
Materials-
**(Changed bulb style to this.)
Assembly-
Cut the wire into 2 equal lengths.
Solder a wire onto each connection on the bulb.
Carefully break the glass of the bulb with the pliers.
Try not to damage the filament....
................................................
Alright... The christmas bulb isn’t gonna work.
Connecting is a pain in the ass.
Find one of these 6v flashlite bulbs.**
Break glass, solder wires to terminals....
................................................
Solder an alligator clip to each wire.
Place the firecracker fuse under the filament,
hold the bulb and firecracker parallel.
Wrap the wire around a couple times.
Tape the whole thing carefully. Be sure
the fuse stays against the filament.
Store it with the alligator clips connected to eachother.
This is so it can’t accidentally go off.
Installation-
Slide under the side of the target car and locate the starter.
It’ll have a big terminal and a small one.
DO NOT CONNECT TO ANY WIRES THAT
GO TO THE BIG ONE!!!!!
If you do, it’ll go off now.
Connect one clip to the wire that goes
to the small terminal, and one to a good ground...
You may have to cut away some of the
insulation on the wire, if you can’t
get to the terminal.
(On the Chevy, it’s the purple wire.
On the Dodge/Mitsubishi, it’s the
small wire on the right.)
Other cars are similar...
If you’re not sure, bring a
small test lite. Connect to the starter
wire that has NO voltage.
The..th..th..the..th..th..the..th..th..That’s all, folks!
(Turn key)
**KaBOOM!**
:-)
Edit Page
Message Dodge
Add Comment
Add to Favorites
Email to Friend
