DO NOT TRY THIS AT HOME : Our text files and message bases are for INFORMATIONAL PURPOSES ONLY. DO NOT undertake any project based upon any information obtained from this or any other web site.We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
(25 votes) Published: Mar 17, 2003 12:00 a.m. Viewed 685 times
What You Will Need
An old sardine tin. The tin should have high sides, approximately 20 mm high.
An old aluminum cigar tube with its cap. If you don’t have an old one (and not many people would) then buy a new one. See Mal’s hot tip number 1 for something to do with the cigar. Han van Gelderen wrote to say that an egg can be used instead of the cigar tube. Here is what he says:
I’ve learned to make this boat using an egg instead of a cigar tube.
Make two holes at the tips of an egg, blow the contents out of it, glue one hole airtight, fill the egg with water. That’s it. Oh, make an omelet from the egg’s contents and watch your jetboat go while enjoying your omelet.
Some wire.
A food-warmer type of candle in which the wax sits in a small aluminium cup.
To build this you will need a medium-sized nail and a hammer, to punch holes in the sardine tin, and some pliers to twist the wire.
How To Build It
Using a nail and hammer (or a bradawl if you have one) poke four holes in the sardine tin - two on each side as shown in the figure on the right. The holes need be big enough only to put the wire through.
Pass a piece of wire through the two front holes (you decide which is the front).
Lay the cigar tube centrally over the sardine tin. The top of the cigar tube faces the back of the boat. Bend the wire over the top of the cigar tube and then all the way around it so that the two ends of the wire come towards each other as shown in the figure on the left.
Using the pliers, twist the ends of the wire together to tighten the wire loop. As you tighten, twist the cigar tube so that it lies longitudinally in the middle of the sardine tin.
Wrap wire around the cigar tube at the back of the boat and tighten it in the same way as at the front.
When the cigar tube is firmly secured use the pliers to cut excess wire away.
Screw the cap onto the cigar tube tightly and make a mark on its end 2 mm from the top. Remove the cap from the end of the cigar tube and, with the thinnest pin you can find, make as small a hole as you can in the end of the cap where you made the mark.
Lay the candle in the middle of the boat. Use a candle that comes in an aluminum cup. Otherwise the melting wax will run inside the boat, upsetting its balance and causing it to capsize.
The candle-powered jet boat is complete! Fill the cigar tube about one quarter with water and screw the cap on. Light the candle beneath the cigar tube and place the jet boat into a bath tub with water. After a while the water in the cigar tube will boil and cause a jet of steam from the small hole in the cap. The steam jet will give the boat some forward momentum. If water leaks from the cigar tube wrap some tape around the cap to seal it tight. If the boat doesn’t gain any speed, try using two candles under the cigar tube. Alternatively, you can remove the candle from its aluminium holder, and put a cotton ball and some methylated spirits into it.
Edit Page
Message shrekdood
Add Comment
Add to Favorites
Email to Friend