NOTE: This egg was made for the Stinger P30 6mm Hand held Airsoft gun.


Ever wanted to make that Air Soft gun of yours a lot faster?

Just follow these steps and you’re on your way to almost DOUBLING the speed of the gun!

First things first.


Take the gun an pull it back. You’ll get a lip at the back. Take your thumb and pull to the side until it pops off.


It should look something like this.


Slide it off, as well as the spring, and put them aside.


Take a knife and slide it under the side until it pops off.


See that safety? It’s also a pin that locks the barrel in place. NOTE: You’ll want to cock the gun before proceeding!

Slowly slide the pin out.


You should have the barrel and the pin in your hand, just put them off to the side.


Next, you slide that black part off. It comes off really easy.


Now there’s the part that pushes the air. If you’ve cocked the gun, you’ll need to hold that black part really hard and pull the trigger. Then it should come loose


Somethin’ like this.


Make sure you keep everything in a well organised pile. ;)


Take the spring out.
Grab it firmly and stretch it.


Make sure you stretch it out straight. Or it will be very hard to put back.


Put the spring back on the little black part sticking out. And put the black part with the white thing on it on the front of the spring.


Then slide the other black part back onto the other black part, as seen in the photo. Pull it back and click it in. Make sure you don’t pull the trigger! The gun is cocked!


Put the barrel back into place. It has a little groove and you can feel it click in.

Slide the pin back in, and make sure the safety is on the left side.


Put the spring back onto the end of the barrel.


Put the clear plastic part back onto the gun. Start at the barrel and work your way down the gun.
It won’t fit on properly, so you’ll have to push it down CAREFULLY. Chances are it will crack a little bit at the top where the screw is. It’s fine. The gun will still work properly, and when you want to stretch the string again it’ll be easier to get off.


Next, take the side plate and click it back in.


Once you’ve put it back on, it will look the same as it did before you took it apart.


CONGRATULATIONS! You’ve successfully modifyed your Airsoft gun.


Remember, this modification is only temporary. Evenntually, the spring will go back to it’s original state.

Also remember, the gun speed has almost doubled. DO NOT SHOOT THIS AT ANYONE! (Well, you can if you want to, it’s not advised. It really hurts.)