How To: Dollar Bill Ring

A dollar bill:

Ones work best, but I spose you could use any. Hundreds might not work.

A hand, Two is best:

I cut mine off small children, I suggest using your own.

You may want to iron each fold, Personally I wouldn’t bother.
Make sure you do fold each fold tightly and accurately though.

Its kinda hard to explain stuff like this.
Tuts like this always confuse the shit out of me
Who knows how il do writing this one. But here goes.
__________________________________________________________________________


What to do:

Take your dollar:

(Big spenda!)
It’s ESSENTIAL you use a fresh bill, Your weak attempt at a bill, (If you can even call it a bill) wont work.

Make sure Mr. Washington is staring at you
Fold the back, bottom margin up towards you.
For some reason the back margin is a little bigger than the front, So its gotta be the back one.


Fold the top down to meet the bottom, leave about 1mm for the bill to "Give" a little, helps with later folds. Its hard to see in the pic.

Mine is conveniently the wrong way round. The open side of the bill should face you.
(If you rotate the pic 180degrees the bill would be the right way.)

Next fold the top down to the bottom again.
You don’t need to leave any room for give.

Its the right way this time.

Now you need to fold the right hand margin behind the bill


It should look like this exactly:


Fold the left hand side up at a right angle.
It should slice right through the N of One:


Fold the vertical over to the right:


Flip the bill and wrap it around your finger with the large word "ONE" on the outside:


Now you have the finger size hold it as shown:


Fold the tab on the left over and then the little tab underneath the vertical part:



Fold the last part inside the ring and tuck it under that little triangle inside the ring:



And there you go.


Hopefully it’s easy enough to understand, sorry if it isn’t
Good luck.